Silhouette FWD V6-3.4L VIN E (2004)
1. Install the new idle air control O-ring.
2. Install the idle air control valve into the throttle body.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the idle air control valve attaching screws.
Tighten
Tighten the screws to 3 N.m (27 lb in).
4. Connect the IAC electrical connector.
5. Install the canister purge valve.
6. Install the throttle control cable bracket.
7. The powertrain control module (PCM) will reset the idle air control valve whenever the ignition is turned ON, then OFF. Turn the ignition ON,
then OFF.
8. Start the engine and allow the engine to reach operating temperature.
