Silhouette FWD V6-3.4L VIN E (2004)
5. Note the routing of the wiring harness (3) to the air bag inflator module and the retaining clip attachments within the driver seat.
6. Remove the wiring harness retaining clips from the driver seat frame.
7. Remove the wiring harness (3) from the driver seat frame.
8. Remove the inflator module (1) from the driver seat back frame.
9. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required
retention period. Refer to Inflator Module Handling and Scrapping.
INSTALLATION PROCEDURE
1. Install the inflator module wiring harness (3) to the driver seat frame, while guiding the wiring harness through the appropriate spots on the driver
seat frame.
2. Install the wiring harness retaining clips to the driver seat frame.