Silhouette FWD V6-3.4L VIN E (2004)
8. Remove the positive battery cable lead (2) from the stud.
9. Remove the lower cover from the underhood electrical center.
10. Disconnect the electrical connectors from the underhood electrical center.
11. Remove the underhood electrical center.
INSTALLATION PROCEDURE
1. Install the underhood electrical center to the engine compartment.
2. Install the electrical connectors to the underhood electrical center.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the underhood accessory wiring junction block electrical harness bolts to 7 N.m (62 lb in).
3. Install the underhood electrical center lower cover.