Silhouette FWD V6-3.4L VIN E (2004)
16. Disconnect the upper control arm from the knuckle.
17. Using the J 41820, disconnect the lower ball joint from the knuckle.
18. Remove the knuckle.
19. Remove the wheel speed sensor connector bracket from the knuckle.
Installation Procedure
1. Install the wheel speed sensor connector bracket to the knuckle.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the wheel speed sensor connector bracket bolt and nut.
^
Tighten the wheel speed sensor bracket nut to 12 Nm (106 lb in).
3. Install the knuckle.