Silhouette FWD V6-3.4L VIN E (2004)
Band Apply Servo: Service and Repair
Reverse Servo Replacement
Reverse Servo Replacement
Removal Procedure
1. Remove the throttle body air inlet duct. Refer to Air Cleaner Assembly Replacement.
2. Use a large flat-bladed tool in order to depress the reverse servo cover (40).
3. Use a small flat-bladed tool in order to remove the retaining ring (39).
4. Use a small flat-bladed tool in order to pull the O-ring seal (41) out through the slot in the case.
5. Use side cutting pliers in order to cut the servo cover O-ring seal (41).
6. Use a large flat-bladed tool in order to depress the reverse servo cover (40), grasp one end of the cut seal (41) and pull the seal (41) out of the
servo cover (40).
