Silhouette FWD V6-3.4L VIN E (2004)
1. During the installation of the repaired or replacement transmission, do not connect the oil cooler pipes.
Notice: Do not use solutions that contain alcohol. or glycol. Use of solutions that contain alcohol or glycol may damage the J 35944-A, oil cooler
components and/or transmission components.
Important: The J 35944-22 is environmentally safe, yet powerful enough to cut through transmission fluid to dislodge any contaminants from the
cooler. The safety precautions on the label, regarding potential skin and eye irritations associated with prolonged exposure, are typical precautions that
apply to many similar cleaning solutions. It should be noted that according to GM, use of other non-approved fluids for cooler flushing can have an
adverse reaction to the seals inside the transmission.
2. Remove the fill cap (9) on the J 35944-A and fill the flusher tank (4) with 0.6 L (20-21 oz) of J35944-22, using the measuring cup (6). DC) not
overfill.
3. Install the fill cap (9) on the J 35944-A and pressurize the flusher tank (4) to 550-700 kPa (80-100 psi), using the shop air supply at the tank air
valve (2).
4. With the water supply valve (1) on the J35944-A in the OFF position, connect the water supply hose from the J 35944~ to the water supply at the
faucet.
5. Turn ON the water supply at the faucet.
Back Flush
1. Inspect the transmission oil cooler pipes for kinks or damage. Repair as necessary.
2. Connect the J 35944-A to the oil cooler feed top connector.
3. Clip the discharge hose (2) onto the oil drain container.
