Silhouette FWD V6-3.4L VIN E (2004)
1. Position the transaxle mount bracket.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the transaxle mount bracket bolts.
Start with the forward lower bolt and work clockwise to tighten the transaxle mount bracket bolts to 95 Nm (70 ft. lbs.).
3. Remove the utility stand.
4. Install the transaxle mount upper nuts.
Tighten the nuts to 47 Nm (35 ft. lbs.).
5. Install the left engine splash shield. Refer to Splash Shield Replacement - Engine.
6. Install the left front tire and wheel. Refer to Tire and Wheel Removal and Installation.
7. Lower the vehicle.
