Toronado V6-231 3.8L (1986)
4.
Gently pull on wire to remove terminal through back of connector.
5.
If corrosion is white powder and only on contact surface of connector terminal (where mating to sensor terminal occurs), clean only with
a standard contact cleaner, such as CRC Electra Clean, CRC Contact Cleaner or equivalent. Proceed to step 13.
6.
If corrosion is a greenish powder on the contact surface and/or in the area of the crimp to wire, the affected terminal(s) must be replaced.
Follow steps 7 thru 13 for each terminal affected.
FIGURE 3
7.
Cut off old terminal between insulation wings and core wings. Refer to Figure 3. Pull off old seal and remaining piece of terminal.
8.
Strip 1/4 inch of insulation off wire and install new wire seal.
FIGURE 4
9.
Position wire into terminal, Figure 4.
10.
With 18 gauge wire crimpers, crimp terminal core wings.
FIGURE 5
11.
Using rosin core solder, solder hand crimped terminal(s) as shown in Figure 5.
