Toronado V6-3800 3.8L (1988)
Headlamp Motor: Customer Interest
Lighting - Headlamp Door Operating Problems
SUBJECT
TORONADO HEADLAMP DOOR OPERATION
MODELS/YEARS 1986-88 TORONADO AND TROFEO MODELS
NUMBER:
88-T-35
CORP. REF. No.: 878203
DATE:
March 1988
SECTION:
2 and 8B
Toronado and Trofeo headlamp door operation can be affected as follows:
-
Will not open
-
Binds or sticks while opening or closing
-
Noisy
The following items should be checked and repaired whenever any of the above comments are encountered.
1.
The rubber boot covering the actuator manual knob should be checked for appropriate (approx. 3/8") clearance between the top of the boot and the
knob. If the boot is down too far, movement of the knob will be restricted by friction from the boot. Also, if the boot is not down far enough or not
straight, movement will be restricted by the sides of the boot against the side of the manual knob. Remove this boot, if necessary, to verify whether
the condition is electrical or mechanical.
2.
Check for electrical conditions concerning inoperative relays or fuses.
3.
Conditions of noisy, binding, or headlight doors that hang-up can be caused by several items:
A.
Doors hitting on the lower grille extension can be repaired, if the door is hitting on the inside corner, by shimming the lower portion of the
grille forward. If the door is hitting on the outside corner, remove the cornering lamp and relocate the attaching screws to move the lamp
forward. (Make sure the headlamp door is not warped. This condition would require replacement of the door.)
B.
Contact can also be made between the actuator linkage and headlamp support brackets. Cycle the doors and watch for contact or look for
signs of paint removal on the support.
C.
Comments of excessive noise while operating the doors can be any of the above conditions as well as "dry" hinges. Make sure the actuator
linkage and the hinges are lubricated.
WARRANTY INFORMATION:
Labor Operation Number:
T4628
Labor Time:
0.3 hrs.
Trouble Code:
92
