Toronado V6-3800 3.8L (1988)
Front Steering Knuckle: Service and Repair
Fig. 6 Steering knuckle & strut installation
1.
Remove hub assembly as outlined.
2.
Remove nut securing tie rod, then separate tie rod from knuckle.
3.
Cut inner tabs from boot protector J-34754 and install protector over drive axle outer joint.
4.
Remove cotter pin and nut securing lower ball joint and separate ball stud from steering knuckle.
5.
Remove bolts securing strut to steering knuckle, Fig. 6, and the steering knuckle.
6.
Reverse procedure to install.