Toronado V8-307 5.0L (1982)
FIGURE 1
The part numbers are stamped on the bottom of the inboard flange near the converter inlet. Refer to Figure 1.
Proceed to Step 15 if replacement of the converter is not required.
2.
If the converter is of the original type, remove both converter clamps and brackets.
3.
Remove the A.I.R. clamp and pipe.
4.
Remove the converter (using a torch to heat the joints).
CAUTION: The catalytic converter beads contain platinum, palladium and/or rhodium. Additionally, the beads may be finely coated with lead
compounds. Therefore, precautions should be taken to minimize dust generation during the replacement procedure. These precautions
include:
A.
Catalyst dust should be controlled by wetting with water prior to bead removal as described in Step 5.
B.
The use of a suitable dust mask, rubber gloves and safety glasses is recommended when handling catalyst beads.
C.
Applicable OSHA standards should be reviewed.
D.
Allow converter to cool before handling.
5.
Stand the old converter upright on the inlet end and pour 16 ounces of water into the outlet end to control catalyst dust.
FIGURE 1
