Toronado V8-307 5.0L (1982)
g.
Using Tool J-29030-B, BT-7610B, or equivalent, turn both idle mixture needles clockwise until they are lightly seated, then turn each needle
counterclockwise the number of turns specified below.
Carburetor
No. of Turns
17082253
3-3/4
17082255
4
h.
Reinstall carburetor on engine using a new flange mounting gasket, but do not install air cleaner and gasket at this time.
i.
Start engine and run until fully warm, and repeat "Adjusting The Air Bleed valve", Step 2, on previous page.
j.
If unable to set dwell to 35-40~, and the dwell is below 35~, turn both mixture needles counterclockwise one additional turn. If dwell is above
40~, turn both mixture needles clockwise one additional turn. Readjust idle air bleed valve to obtain dwell limits.
After adjustments are complete, seal the idle mixture needle openings in the throttle body, using silicone sealant, RTV rubber, or equivalent.
The sealer is required to discourage unnecessary adjustment of the setting, and to prevent fuel vapor loss in that area.
Idle Speed
Recheck ILC and base idle screw for proper adjustment.
Warranty Information
Operation
Year
Operation No.
Labor Time
T/C
Failed P/N
PROM Replacement
1982
J6364
0.5
92
1226377
(Only)
If carburetor adjustments are performed, submit as a separate claim, the appropriate labor operation from the 1982 Labor Time Guide.
A system performance check is not required for this repair.
