505 V6-2849cc 2.8L ZN3J (1987)
Repair of Cause A:
-
Remove the accessory power board (one phillips head screw)
-
Remove the power steering ECU from its location (held in place by two Phillips-head sheetmetal screws through two sheetmetal clips)
-
Glue a piece of 13 mm (1/2 inch) thick 25 x 50 mm (1 x 2 inches) medium density foam rubber, neoprene or similar, in the area indicated on the
drawing below (use self-sticking material if available)
-
Reinstall ECU in reverse order
Repair of Cause B:
-
Loosen the two mounting nuts (10 mm hex head) for the cruise control ECU and the two nuts (8 mm hex head) holding the climate control ECU
-
Move both ECU's in opposite directions on their elongated mounting eyelets in order to avoid possibility of touching
-
If there is still a possibility of the two ECU's making contact with each other, carefully bend the two frame eyelets, for mounting the cruise control
ECU, rearwards; this will give the cruise control ECU a more upright position out of the way of the climate control ECU