Acclaim L4-153 2.5L SOHC Flex Fuel (1994)
Parking Brake Shoe: Service and Repair
1. Raise and support vehicle.
2. Remove rear wheel and tire assembly.
3. Remove caliper from rotor as described under Brake Pad/Service and Repair.
4. Remove rotor from hub.
5. Remove grease cap, cotter pin, locknut, retaining nut, washer, hub and bearings.
6. Using a suitable tool, remove forward hold-down clip.
7. Turn adjuster wheel until adjuster is at its shortest length, then remove adjuster assembly.
8. Remove upper shoe to shoe spring.
9. Pull front shoe away from anchor, then remove front shoe and lower spring.
10. Using a suitable tool, remove rear hold-down clip and shoe.
11. Reverse procedure to install noting the following:
a. Adjust shoe diameter to 6.75 inches.
b. Tighten wheel bearing adjusting nut to specifications while rotating hub to seat bearings, back off adjusting nut 1/4 turn, then tighten finger
tight.
c. Align nut-to-spindle holes for cotter pin insertion.
