Acclaim V6-181 3.0L SOHC (1990)
Fuel Injector: Testing and Inspection
Fuel Injector Balance Test
NOTE: Make sure injectors have been cleaned with an approved cleaner prior to testing. See: Service and Repair/Fuel Injector Cleaning Procedure
The injector balance test is done to verify a balanced distribution of fuel to all cylinders.
1.
Start by hooking up a fuel pressure gauge at the schrader valve or inline before the fuel pressure regulator (refer to gauge manufacturer
instructions).
2.
Pressurize the fuel system to operating pressure of 330 kPa (48 psi). See: Service and Repair/Fuel System Pressurizing Procedure
^
If pressure is not within specifications diagnose and repair problem before proceeding.
3.
Remove injector harness connector and connect an injector pulse tester.
4.
Pulse one injector at a time. Allow pressure to rise and stabilize in between each injector tested.
NOTE: The time each injector is pulsed is very important. Each injector should be pulsed at the same time interval, (for example 1 ms each).
5.
The rate of drop should be even across all the injectors. All pressure drops should be within 3% of each other, if not replace injector.
6.
If there is no pressure drop when injector is pulsed, verify there is a good connection between the injector and pulse tester. If connection is good,
a check of the injector circuit is required.
7.
First, check the resistance of the injector, if resistance is OK verify there is power to injector by reconnecting the injector harness connector and
START engine.
8.
Use a "NOID" light to check for pulses (light flashes).
^
If light does not flash this is an indication of a problem in the injector to SBEC circuit.
^
If light pulses, recheck pressure drop to verify malfunction.
NOTE: It may not be possible to connect a noid light to the harness while connected to injector. If this is the case disconnect harness and connect
noid light to harness and check pulses.
