Acclaim V6-181 3.0L SOHC (1990)
NOTE:
THE ABOVE PARTS HAVE BEEN UPDATED. THE UPDATED PARTS CAN BE IDENTIFIED BY THE BIACK PLASTIC
CARRIER WHICH EXTENDS INTO THE TRANSMISSION, AS SHOWN IN THE ILLUSTRATION BELOW.
REPAIR PROCEDURE
This repair involves replacement of the PRNDL switch and the neutral safety switch.
1.
Disconnect the battery negative cable.
2.
Replace the PRNDL and neutral safety switches as outlined in the appropriate service manual.
3.
Place a dab of white touch-up paint on both switches to identify they have been replaced.
4.
Connect the battery negative cable.
5.
Connect the DRB II, clear any exiting transmission fault codes.
6.
Road test the vehicle a sufficient distance to ensure the transaxle is warm. With the shift lever in the 0D position, perform several 0 to 50 MPH
accelerations, being sure the transmission shifts through all gears.
7.
Using the DRB II after the road test, recheck transmission for any fault codes. if any fault codes are present, use the appropriate diagnostic
procedures to repair.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No.
08-80-56-90
0.5 Hrs.
FAILURE CODE:
61 - Intermittent Operation
