Breeze L4-2.0L VIN C (1997)
Then rotate caliper into position at bottom of steering knuckle.
NOTE: When installing guide pin bolts, extreme caution should be taken not to cross thread the caliper guide pin bolts.
8. Install the caliper guide pin bolts and tighten to a torque of 22 Nm (16 ft. lbs.).
9. Install the wheel and tire assembly.
10. Tighten the wheel mounting stud nuts in proper sequence until all nuts are torqued to half specification. Then repeat the tightening sequence to the
full specified torque of 109 - 150 Nm (80 - 110 ft. lbs.).
11. Remove jackstands or lower hoist. Before moving vehicle, pump the brake pedal several times to insure the vehicle has a firm brake pedal.
12. Road test the vehicle and make several stops to wear off any foreign material on the brakes and to seat the brake shoes.
