Breeze L4-2.0L VIN C (1997)
Rear Brake Drum
7. Install rear brake drum on hub/bearing assembly.
8. Install rear wheel and tire assembly on vehicle. Tighten all wheel stud nuts in criss cross pattern to one-half specified torque. Then repeat pattern,
fully tightening stud nuts to 109 - 150 Nm (80 - 110 ft. lbs.).
9. Lower vehicle.
10. Grasp park brake cable to floor pan seal grommet by hand, and pull it into floor pan to ensure seal grommet is fully seated into floor pan.
Park Brake Cable Installed In Console Bracket
11. Route park brake cable under carpeting and up to park brake cable hole in console bracket on floor pan. Then install park brake cable into console
bracket. Be sure tabs on park brake cable retainer, have expanded out to hold park brake cable in console bracket.
Park Brake Cable Attachment To Floor Pan
12. Install the routing bracket holding park brake cables to the floor pan of the vehicle.
CAUTION: Discard output cable retaining clip and tension equalizer after removing it from the park brake output cable. A new tension equalizer
and retaining clip is to be used when installing a new rear park brake cable.
