Breeze L4-2.0L VIN C (1997)
5. Remove the cubby bin/cigar lighter bezel and wiring.
6. Remove the control module retaining screws.
Fig 68 Control Module At Bezel Opening
7. Drop the A/C control module into the cigar lighter/cubby bin bezel opening. Then disconnect the wiring on the rear of the control module.
8. Release the recirculation cable retaining clip from the top of the control module. Retain the clip for future use. Then disconnect the recirculation
control cable.
9. Remove right under panel silencer/duct.
Fig 69 Disconnect Recirculation Cable
10. Disconnect cable flag at right of recirculation housing.
11. Remove cable core end from recirculation actuator lever.
INSTALLATION
For installation, reverse the above procedures. Verify that the cables are property adjusted, free of interference, and the module is seated properly.
