Breeze L4-2.0L VIN C (1997)
Bus (+) & (-) Shorted Together
The two bus wires are shorted together.
No Termination
The bus system has lost connection with all of its terminators.
Bus Bias Level Too Low
Either or both of the bus wire potentials are significantly below their normal 2.5 volts.
Bus Bias Level Too High
Either or both of the bus wire potentials are significantly above their normal 2.5 volts.
No Bus Bias
The bus system has lost connection with all modules that provide bias.
Bus (+) Open
The bus (+) wire has lost connection with termination and/or bias.
Bus (-) Open
The bus (-) wire has lost connection with termination and/or bias.
Not Receiving Bus Messages Correctly
The DRB cannot communicate over the bus and does not know why.
Wiper System
WIPER SYSTEM
The front wiper system provides the driver with normal wipe (low and high speeds), intermittent wipe, wiper after wash, and mist wipe functions.
The driver selects the wiper function via a resistive multiplexed stalk switch mounted on the steering column.
Other wiper system features:
Speed Sensitive Intermittent Wipe Mode
There are 6 individual delay times with a minimum delay of 1/2 second to a maximum of 18 seconds. When the vehicle speed is under 10
MPH, the delay time is doubled providing a range of from 1 second to 36 seconds.
Mist Wipe
When the wiper is in the off position and the driver presses the mist control for more than 125 msec, 1 wipe cycle in low speed mode will be
provided. The wipe will continue in low speed as long as the switch is held in that position.
Wiper After Wash Mode
When the driver presses the wash button for over 3/8 second and then releases it, the wiper will continue to run for 2 additional wipe cycles.