Breeze L4-2.0L VIN C (1997)
1. Install steering gear assembly on front suspension crossmember. Install the 2 long steering gear assembly to front crossmember mounting bolts into
the mounting isolators. Then install the 2 short bolts into the saddle bracket. Tighten the 4 steering gear mounting bolts to a torque of 68 Nm (50 ft.
lbs.).
2. Install the power steering fluid pressure and return lines on the ports of the power steering gear. Tighten power steering fluid pressure and return
lines to steering gear tube nuts to a torque of 31 Nm (275 inch lbs.).
3. Using transmission jack, raise front suspension crossmember and steering gear against body of vehicle. Start the 2 rear bolts into tapping plates,
attaching front suspension crossmember to body of vehicle. Then install the 2 front bolts, attaching front suspension crossmember to frame rails of
vehicle. Tighten the 4 mounting bolts evenly until front suspension crossmember is against body of vehicle at the 4 mounting points. Then torque
the 4 mounting bolts to 2 Nm (20 inch lbs.) to hold front suspension crossmember in position.
CAUTION: When front suspension crossmember is installed back in vehicle, crossmember MUST be aligned with positioning marks previously
scribed into body of vehicle. This MUST be done to maintain NET BUILD front suspension alignment settings.
