Breeze L4-2.0L VIN C (1997)
18. Fill power steering pump fluid reservoir to the (Full-Cold) proper level.
19. Start the engine and let run for a few seconds. Then turn the engine off.
20. Add fluid if necessary.
21. Raise front wheels of vehicle off the ground.
22. Start engine and turn steering wheel several times from stop to stop to bleed air from fluid in system. Stop engine, check fluid level, and inspect
system for leaks. Fill pump reservoir to correct level with Mopar, Power Steering Fluid, or equivalent.
23. Lower front wheels of vehicle back on the ground.
CAUTION: During this procedure do not allow the steering gear inner tie rod boots to become twisted.
24. Check front alignment and adjust the front Toe setting on the vehicle.
25. Tighten tie rod jam nut to 74 Nm (55 ft.lbs.) torque.
26. Adjust steering gear to tie rod boots at tie rods.
