Breeze L4-2.0L VIN C (1997)
Wiper Arm: Service and Repair
Wiper Arm and Blade
REMOVAL
1. Place the wiper arm/blades in the PARK position and turn ignition OFF.
2. Unsnap arm cover. By hand rock gently side to side and slide away from arm pivot. To remove the left side raise hood for clearance
3. Loosen retention nut.
4. Remove the arm from the pivot by using a universal claw puller or by hand rock gently side to side and slide. Raise blade and arm off glass and
rock side to side while applying pressure with the puller till loose. Ensure that the puller is not on the collar below the arm.
5. Remove arm retention nut and arm.
INSTALLATION
1. Place arm on pivot shaft, align arm with key- way and push down on arm to start on pivot shaft.
2. Start retention nut.
3. Raise arm and blade off windshield while tightening retention nut. Tighten nut to 37 to 43 N. mm (27 to 32 ft.lbs.).
4. Install arm head cover.
