Breeze L4-2.4L VIN X (2000)
6. Install a Pressure Gauge, Special Tool C-4)07-A into each pressure test fitting. Bleed air out of hose from pressure test fitting to pressure gauge, at
pressure gauge to remove all trapped air.
7. With the aid of a helper, apply pressure to the brake pedal until reading on proportioning valve inlet gauge, is at the pressure shown on the
following chart, Proportioning Valve Applications And Pressure Specifications. Then check the pressure reading on the proportioning valve outlet
gauge. If proportioning valve outlet pressure does not agree with value shown on the following chart, when inlet pressure shown on chart is
obtained, replace the proportioning valve. If proportioning valve is within pressure specifications do not replace proportioning valve.
8. Check rear wheel brake shoe linings for contamination or for replacement brake shoes not meeting OEM brake lining material specifications.
These conditions can also be a possible cause for a premature rear wheel skid.
9. Install proportioning valve on end of brake flex hose. Tighten the proportioning valve to a torque of 17 Nm (145 inch lbs.).
10. Install brake tube on proportioning valve. Torque tube nut to 17 Nm (145 inch lbs.) torque.
11. Bleed the affected brake line. Refer to Brake Bleeding, Service and Repair.
PROPORTIONING VALVE APPLICATIONS AND PRESSURE SPECIFICATIONS
