Colt L4-1753cc 1.8L SOHC (1989)
INSPECTION:
-
Check the hub for cracks and spline for wear.
-
Check the oil seal for damage.
-
Check the knuckle for cracks.
-
Check for defective bearing.
SERVICE POINTS OF REASSEMBLY
6. Installation of bearing outer races
1. Apply multi-purpose grease to the outside surface of the bearing outer races.
Grease: MOPAR Multi-mileage Lubricant Part Number 2525035 or equivalent
2. Drive the bearing outer races into the knuckle by using the special tools.
5. Installation of oil seal (hub side)
1. Apply multi-purpose grease to the bearings and inside surface of the hub.
Grease: MOPAR Multi-mileage Lubricant Part Number 2525035 or equivalent
2. Place the outside bearing inner race into the knuckle.
3. Apply multi-purpose grease to the lip of the oil seal and to the surfaces of the oil seal which contact the hub.
4. Drive the oil seal (hub side) into the knuckle by using the special tools.
3. Installation of front hub
1. Set up the special tool as illustrated. While holding the bolt, turn the nut in the tightening direction to insert the front hub in the knuckle. After
the front hub has been completely inserted, tighten the nut to the 200-260 Nm (144-188 ft.lbs) torque.
2. Rotate the front hub in order to seat the bearings.
