Colt Vista 2WD L4-1997cc 2.0L SOHC (1984)
at the specified idle-up rpm (Figure 1).
FIGURE 2
If necessary, turn off the air conditioning switch and make a fine adjustment to the idle-up speed adjusting screw for air conditioner (Figure 2). (Turning
this screw clockwise will decrease the engine speed, turning it counterclockwise will increase engine speed.)
9.
Turn SAS 3 through an angle twice the turning angle of SAS 2 as recorded in Step 5, in the same direction as SAS 2.
Example:
If Sas 2 has been turned 180~ clockwise in Step 5, SAS 3 will be turned 360~ clockwise in Step 9. Then, lift the
free lever by hand until it touches SAS 3 and make sure that the engine rpm is "N" +/- 100 rpm (where "N" is the
rpm recorded in Step 4). If necessary, adjust using SAS 3.
FIGURE 2
SIMPLE ADJUSTMENT PROCEDURE FOR COLT VISTA ONLY
If the idle adjustment has been properly made before installation of the air conditioner, the following simple procedure may be used:
1.
Give one clockwise turn to SAS 2 (Figure 2).
2.
Give two clockwise turns to SAS 3 (Figure 2).
3.
Back off idle-up speed adjusting screw for air conditioner one turn from fully tightened position (Figure 2).