Colt Vista 2WD L4-2350cc 2.4L SOHC (1993)
f.
Install setscrew tool No. MD998738 or equivalent, into engine left support bracket until its end makes contact with tensioner arm, Fig. 49.
g. Turn setscrew tool to increase the pressure on the tensioner arm then remove wire from tensioner set holes.
h. Rotate crankshaft two complete turns clockwise and allow to sit for 15 minutes.
i.
After 15 minutes, measure auto tensioner rod protrusion, and verify that it is within the .15-.18 inch specification. If not as specified, repeat
steps a through h.
j.
Install rubber plug to the timing belt rear cover.
Fig. 50 Timing belt cover installation 1993-94 2.4L/4-143.5 engine
13.
Install timing belt cover screws into proper location as shown in Fig. 50.