Colt Vista 4WD L4-1997cc 2.0L SOHC (1985)
Figure 12
3.
Using a tachometer, check the idle speed. If it is not between 650 - 850 RPM, readjust it to 750 RPM using idle speed adjusting screw
No. 1 (SAS1) (Figure 12).
4.
After the idle speed has been verified, adjust the basic ignition timing to 8 degrees BTDC using the Service Manual Procedure.
NOTE:
This is a new basic timing specification.
Recheck the idle speed and adjust if necessary.
5.
Disconnect tachometer and reinstall air cleaner assembly.
H.Install New Hose Routing and Recall Completion Labels
Figure 13
1.
Locate the hose routing label on underside of the hood as shown in Figure 13.
2.
Remove all dirt from the old label. Install the new hose routing label over the old label.
3.
With a ball point pen, print your dealer code (5 digits) on the supplied Recall Completion Label.
4.
Peel the label from its backing and apply it near the Vehicle Emission Control Information Label.
Completion Reporting and Reimbursement
Claims for vehicles which have been serviced must be submitted on the DIAL System. Claims submitted will be used by Chrysler to record recall service
completions and provide dealer payments.
