Colt Vista 4WD L4-1997cc 2.0L SOHC (1985)
7.
Remove the jet mixture solenoid valve (Figure 2).
8.
Insert the new jet mixture solenoid valve and hand tighten it.
CAUTION:
If the solenoid threads seem to bind when tightening by hand, do NOT use force. Loosen and retighten to remove burrs and avoid
crossthreading.
9.
Place the provided JMS tool on the provided inch-pound torque wrench (Figure 3).
NOTE:
The JMS tool must be at a 90 angle to the torque wrench to assure a correct torque reading.
10.
Tighten the jet mixture solenoid to 26 in-lbs torque.
NOTE:
Do not over tighten the jet mixture solenoid valve since this will distort the valve and cause an over rich condition.
11.
Connect the jet mixture solenoid electrical connector.
B. Install Carburetor Choke Adjustment Shim
