plymouth Workshop Repair Guides

Plymouth Workshop Service and Repair Manuals

Recalls for Exhaust Gas Recirculation: > < Recall - Excessive CO & HC Emission & Exhaust Leak|Page 1749
Page 9
background image

Dealer Instructions

IMPORTANT

DEALER INSTRUCTIONS
CALIFORNIA EMISSIONS RECALL # 290T -- HC AND CO EMISSIONS AND EXHAUST MANIFOLD

^

This recall applies only to 1985 Model Year Plymouth and Dodge Colt Vista 4WD vehicles equipped with a 2.0L carbureted engine and
California emissions control system.

^

The following service steps are required:

-

Clean choke shaft and replace carburetor primary air bleed jet.

-

Install carburetor choke shim.

-

Install vacuum harness.

-

Adjust idle speed.

-

Inspect exhaust manifold for leaks and replace if necessary.

-

Install new hose routing and recall completion labels.

^

The California Air Resources Board (CARB) will be performing an audit of vehicles serviced for this recall.

Failure to perform all steps of the recall service procedure complete and accurately may cause emissions noncompliance. Further, CARB considers
failure to properly perform emissions recall procedures to be a violation which may subject the servicing dealer to a significant fine.

^

A service procedure checklist is provided on the reverse side of the instruction Sheet enclosed with each Emissions Service Parts Package, PN
C3940373. The servicing technician should complete, sign and date the checklist, to be retained by then dealership as a permanent record of recall
service completion.

Recalls for Exhaust Gas Recirculation: > < Recall - Excessive CO & HC Emission & Exhaust Leak|Page 1749