Colt Vista FWD L4-1795cc 1.8L SOHC (1994)
8. If not within the standard value range turn the engine speed adjusting screw to make the necessary adjustment.
NOTE: If the idling speed is higher than the standard value range even when the engine speed adjusting screw is fully closed check whether or
not there is any indication that the fixed SAS has been moved. If there is an indication that it has been moved adjust the fixed SAS. If there are no
indications that it has been moved it is possible that there is leakage as a result of deterioration of the Fast Idle Air Valve (FIAV) and if so the
throttle body should be replaced.
9. Switch OFF the ignition switch.
10. If the scan tool was not used disconnect the jumper wire from the diagnostic test mode control terminal.
11. Disconnect the jumper wire from the ignition timing adjustment terminal and return the connector to its original condition.
12. Start the engine again and let it run at idle speed for about 10 minutes; check to be sure that the idling condition is normal.
