plymouth Workshop Repair Guides

Plymouth Workshop Service and Repair Manuals

Lamps and Indicators - Transmission and Drivetrain > < Drive/Propeller Shaft|Service and Repair|Page 5691
Page 4
background image

Fig.16 Driveshaft Boot Band Installation

11. Set double offset joint boot bands from 2 3/4 - 3 1/4 inches apart as shown, then tighten boot band C securely.
12. Pull part of double offset joint boot away from double offset joint outer race to allow pressure to escape from boot, then tighten boot band B

securely to double offset joint outer race.

Lamps and Indicators - Transmission and Drivetrain > < Drive/Propeller Shaft|Service and Repair|Page 5691