Colt Vista FWD L4-1795cc 1.8L SOHC (1994)
Fig.3 Pressing Front Drive Axle From Hub
e. When removing RH driveshaft, use two screwdrivers as shown.
Fig.5 RH Driveshaft Inner Joint Removal
f.
When removing LH driveshaft, insert a suitable pry bar between transaxle case and outer case of double offset joint, then withdraw drive axle.
Cover drive axle opening in transaxle. When removing drive axle, support at tripod or double offset joint and pull shaft straight out to prevent
damage to boot or joint. After disconnecting drive axle from transaxle, support shaft in proper position. Pry bar should not be inserted more
than .28 inch between transaxle case and outer case of offset joint, as damage to oil seal may result. The double offset joint retainer ring should
be replaced whenever the drive axle is removed from transaxle case.
