Colt Wagon 2WD L4-1468cc 1.5L SOHC (1990)
Crankshaft Main Bearing Seal: Service and Repair
Fig. 31 Disassembled View Of Oil Seal Case
Fig. 32 Installing Rear Seal Into Case
1.
Remove transmission, clutch assembly and flywheel or flex plate, as equipped.
2.
Remove rear oil seal case and separate: oil seal, case and separator, if equipped. Fig. 31.
3.
Drive in oil seal from inside of case, using suitable tool, Fig. 32. Ensure the oil seal plate fits properly in the inner contact surface of the seal case,
if equipped.
4.
Install separator with the oil hole facing the bottom of the case, if equipped.
5.
Apply engine oil to oil seal lips.
6.
Install the oil seal case in the cylinder block.