Colt Wagon 2WD L4-1468cc 1.5L SOHC (1990)
4.
Fabricate a short jumper using the 10" length of wire and a suitable terminal that will fit the battery ground connector/stud on the dash. Solder this
jumper wire to the inboard splice located in step 3. It is recommended that the splice be cleaned and soldered to assure a good electrical
connection to the jumper wire. Connect the terminated end of the jumper wire to the battery ground connector/stud on the dash.
5.
Clean and solder the outboard splice, located in step 3, to assure a good electrical connection at this splice.
6.
Perform a continuity check of the green/black stripe wire from the outboard splice to the battery ground connector/stud on the dash.
7.
Tape the splices with electrical tape and install the wire harness back into the plastic corrugated harness protector. Tape the entire length of the
plastic protector that was opened to gain access to the harness.
8.
Install the battery
9.
Restore the radio station presets recorded in step 1.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No:
08-90-65-91
0.5 Hrs.
FAILURE CODE: XX - Service Adjustment
