Colt Wagon 2WD L4-1468cc 1.5L SOHC (1990)
when door is closed and slide anchor is in fasten range (fasten switch Off).
34.
If resistance indicated is as specified, circuit is satisfactory.
35.
If resistance is not as specified, repair harness or replace motor and track assembly as necessary.
Fasten Switch Test
Fig. 6 Checking Fasten Switch
1.
Remove the fasten switch.
2.
Using a suitable ohmmeter, check for continuity between switch terminals.
3.
Continuity should be present with switch knob released and no continuity should be present with the knob pushed in.
Outer Switch Test
Fig. 8 Checking Outer Switch
1.
Disconnect the outer switch connector.
2.
Pull the shoulder belt out farther than its midpoint.
3.
Using a suitable ohmmeter, check continuity as shown.
4.
Continuity should be present with the belt pulled out past its midpoint.
5.
No continuity should be present when belt is pulled out less then its midpoint.
Release Switch (Driver's Side) Test
NOTE: Refer to SCHEMATIC DIAGRAMS/ELECTRICAL AND ELECTRONIC DIAGRAMS when performing these tests.
1.
Check release switch (driver's side) circuit as follows:
a. Disconnect release switch harness connector.
b. Connect a suitable ohmmeter between release switch connector terminal 1 and ground.
c. Ohmmeter should indicate continuity.