Colt Wagon 2WD L4-1468cc 1.5L SOHC (1990)
Fig. 41 Drive Pinion Turning Torque Specifications (Less Oil Seal Installed)
Fig. 42 Selecting Drive Pinion Adjustment Shims
Fig. 43 Drive Pinion Inner Race Installation
3. Adjust drive pinion height as follows:
a. Install a pinion height gauge set, tool Nos. MB990835 and MB990836, or equivalent. Drive pinion front and rear bearing inner races into gear
carrier as shown.
NOTE: Apply a thin coat of multipurpose grease to mating surface on washer of tool.
b. Tighten handle of tool until standard value of drive pinion turning torque is obtained.
c. Measure drive pinion turning torque (without oil seal).
d. Position tool No. MB990835 or equivalent in side bearing seat of gear carrier as shown. Select a drive pinion rear shim of a thickness which
corresponds to the gap between tools.
NOTE: Clean side bearing seat thoroughly. When positioning tool, ensure that cut-out sections of tool are in position shown, and that tool is
in close contact with side bearing seat. When selecting drive pinion rear shims, keep number of drive shims to a minimum.
e. Fit selected drive pinion rear shims to drive pinion, then using bearing installer tool No. MB990728 or equivalent, press rear bearing inner race
onto drive pinion as shown.
Fig. 44 Checking Drive Pinion Turning Torque
