plymouth Workshop Repair Guides

Plymouth Workshop Service and Repair Manuals

Turbocharger - Lack of Boost/Grinding Noises|Page 1840 > < Diagram Information and Instructions|Page 1831
Page 1
background image

Turbocharger: All Technical Service Bulletins
Turbocharger - Lack of Boost/Grinding Noises

Models

1984 Conquest

Subject

Lack of Turbocharger Boost and/or Grinding Noise From the Turbo Assembly

Index

FUEL

Date

(current)

No.

14-23-85

SYMPTOM/CONDITION

Lack of turbocharger boost which results in poor engine performance and/or grinding noises from tubocharger assembly..

DIAGNOSIS

Follow the turbo diagnosis and inspection procedure that is described on page 14-19 of the 1984 Conquest Service Manual, publication #81- 270-4005.
If it is determined the turbine cartridge bearings have failed, proceed with the installation of the water cooled turbocharger conversion kit outlined below.

PARTS REOUIRED

1

Turbo Cartridge, Water Cooled

PN MD613504

1

Turbo Plumbing Kit

PN MD997171

1

Turbo Cartridge "O" Ring

PN MD613776

1

02 Sensor Gasket

PN MD041864

1

Exhaust Manifold Gasket

PN MD102683

1

Oil Pipe Joint

PN MD017359

1

Oil Pipe Joint Gasket

PN MF660064

NOTE:

FOR COMPONENT PART SERVICE OF THE WATERCOOLED TURBO SYSTEM REFER TO THE 1985 CONQUEST
PARTS CATALOG.

REPAIR PROCEDURE

1.

Disconnect negative terminal of battery.

2.

Drain engine coolant and oil. Remove air filter to turbocharger rubber air inlet duct and set it aside. Save coolant.

Turbocharger - Lack of Boost/Grinding Noises|Page 1840 > < Diagram Information and Instructions|Page 1831