Gran Fury V8-318 5.2L VIN K 2-bbl (1982)
Brake Bleeding: Service and Repair
Flushing Hydraulic System
Fig. 21 Bleeding Wheel Cylinder
Whenever new brake components are installed in the hydraulic system, it is recommended that the entire hydraulic system be thoroughly
flushed with clean brake fluid.
It may sometime become necessary to flush out the system due to the presence of mineral oil, kerosene, gasoline, etc., which will cause swelling of
rubber piston cups and valves so they become inoperative. The procedure is as follows:
Flushing is performed at each wheel in the same manner as the bleeding operation except that the bleeder valve is opened 1-1/2 turns and the fluid is
forced through the lines and bleeder valve until it emerges clear in color. Approximately one quart of clean brake fluid is required to flush the
hydraulic system. After completing the flushing operation at all bleeder valves, check to ensure the master cylinder is filled to the proper level.
