Gran Fury V8-318 5.2L VIN K 2-bbl (1982)
Ignition Switch: Adjustments
EXCEPT CORDOBA & MIRADA
1.
Disconnect battery ground cable.
2.
Place transmission in Park and ignition lock in the lock position.
3.
If switch was not removed from column, loosen two mounting bolts and insert a lock pin into hole on switch marked lock. If switch was removed
from column, pin switch in the lock position, then place switch into rod and rotate 90 degrees over mounting holes. Loosely install mounting bolts.
Replacement switches are supplied with locking pins.
4.
Apply light upward pressure to align rod and switch and hold switch in this position while tightening retaining bolts. Remove locking pin.
5.
Remove lock pin from switch.
6.
Reverse procedure to install.
