Grand Fury/Salon V8-318 5.2L VIN P 2-bbl (1984)
Cabin Temperature Sensor / Switch: Testing and Inspection
1. Remove glove compartment, then disconnect in-car sensor from wiring harness. Do not disconnect aspirator assembly or remove sensor from
instrument panel.
2. Check aspirator assembly as described under "Aspirator Test."
3. Position a thermometer into air inlet grille near in-car sensor, then set blower motor speed to M2. Depress Max. A/C push button, then pull push
button out to turn A/C compressor off and close water valve.
4. With blower motor operating, connect ohmmeter to in-car sensor wire terminals. Resistance of the in-car sensor should be between 1100 and 1800
ohms at a temperature of 70-80°F. Do not leave ohmmeter connected to in-car sensor longer than 5 seconds, or an inaccurate resistance
reading may be obtained.
