Grand Fury/Salon V8-318 5.2L VIN P 2-bbl (1984)
Air/Fuel Mixture: Adjustments
Idle Mixture (Propane Method)
Fig. 1 Carburetor enrichment tool
This procedure should only be used after normal diagnosis has revealed no other faults, or if carburetor has been overhauled. Idle mixture adjustment
requires artificial propane enrichment. A propane enrichment tool, C-4464 or equivalent, Fig. 1, must be used to adjust idle mixture. Before proceeding,
make sure that propane cylinder is adequately filled to ensure correct propane flow.
Fig. 2 Propane enrichment specification chart
CARTER BBD & THERMO-QUAD CARBURETORS
1.
Remove concealment plug or limiter cap from mixture adjusting screw. Refer to ``Carburetor Section.''
2.
Set parking brake and place transmission in Neutral position.
3.
Turn off all lights and accessories, then connect tachometer.
4.
Start engine and allow to reach normal operating temperature.
5.
Disconnect and plug vacuum hose at EGR valve, if equipped.
6.
On models equipped with carburetor ground switch, connect jumper wire between switch and ground.
7.
On models not equipped with Spark Control Computer (SCC), disconnect and plug vacuum hose from carburetor, at heated air temperature sensor
and OSAC valve, if equipped, then remove air cleaner.
8.
On models with SCC, air cleaner cannot be removed but may be propped up.