Grand Voyager L4-153 2.5L SOHC (1989)
Figure 2
2.
Lift the head cover and remove the wiper arm attaching nut (see Figure 2).
3.
Remove wiper arm from the pivot using a rocking motion.
4.
Using a wire brush, clean the wiper pivot shaft splines thoroughly to remove any metal filings.
5.
Cycle the windshield wiper motor to the park position and install wiper arm as follows:
-
For AC, AH, AP and AA bodies position wiper arm so that blade tip is 3/4" from top of cowl screen.
-
For AS body, position wiper arms so that blade tips are located as follows:
Left:
5.0 mm (2.0") above windshield cowl top
Right:
2.5 mm (1.0") above windshield cowl top
6.
Tighten the retaining nut to the torque value indicated below.
-
For vehicles with a 10 mm pivot shaft nut (built prior to February, 1989) torque to 120 in.lbs (14 N-m).
-
For vehicles with a 13 mm pivot shaft nut (built after February, 1989) torque to 175 in.lbs (20 N-m).
7.
Run wiper motor to check for correct operation of wiper arms.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operations No.
23-43-60-90
. . . . . . . . . . . . . . . 0.2 Hrs.
FAILURE CODE:
K4 - Loose