Grand Voyager L4-2.4L DOHC (1996)
Rear Bumper Cover / Fascia: All Technical Service Bulletins
Liftgate to Rear Fascia - Gap Too Small
NO: 23-56-95
GROUP: Body
DATE: Sep. 8, 1995
SUBJECT:
Liftgate To Rear Fascia Gap Too Small
MODELS:
1996 (NS) Town & Country/Caravan/Voyager
1996 (GS) Chrysler Voyager (European Market)
SYMPTOM/CONDITION:
The gap between the rear fascia and the liftgate is too small, or possibly interference may exist.
DIAGNOSIS:
Measure the gap between the bottom of the liftgate and the top surface of the fascia. If anywhere along the gap the clearance is less than 1/8 in. (3 mm),
perform the Repair Procedure.
PARTS REQUIRED:
4
6500911
Rivet
REPAIR PROCEDURE:
This bulletin involves adjusting the rear fascia support/bumper reinforcement and fascia locating brackets.
1.
Open the liftgate.
2.
Raise the vehicle on an appropriate hoist.
3.
Remove the 3 screws holding the rear fascia in each wheel well areas.
