Grand Voyager L4-2.4L DOHC (1996)
4.
Remove the 4 plastic rivets holding the bottom of the rear fascia to the rear bumper/fascia support.
5.
Disengage the hooks on the sides of the fascia from the slots in the locating/mounting bracket.
6.
Separate the rear fascia from the vehicle.
7.
Close the liftgate and measure the rear bumper fascia support to liftgate gap and adjust as necessary to obtain a 1/2 in. (12.5 mm) gap, refer to
Figure 2.
8.
Measure the vertical location of the rear fascia locating/mounting brackets under the tail lamp portion of the quarter/aperture panel, a 3/8 in. (9
mm) gap should exist, refer to Figure 3. If the rear fascia locating/mounting brackets require adjustment, mark the location of the sides of the
brackets on the quarter/aperture panel to aid in proper alignment during reinstallation. Remove the two attaching screws for each bracket and slot
the holes in the brackets to allow adjustment in the required direction. Install the rear fascia locating/mounting brackets. and position to obtain a
3/8 in. (9 mm) gap.
9.
Open the liftgate and engage the tabs on the back of the fascia into the slots in the rear bumper/fascia support. Engage the side hooks on the fascia
onto the locating/mounting brackets.
