Grand Voyager L4-2.4L DOHC (1996)
Door Lock Cylinder: Service and Repair
REMOVAL
1. Remove front door trim panel and water shield as necessary to gain access to the outside door handle.
2. Roll door glass up.
3. Through access hole at rear of inner door panel, if equipped, disengage vehicle theft alarm (VTA) switch from back of lock cylinder.
4. Disengage clip holding lock linkage to lock cylinder link arm.
5. Separate lock linkage from lock cylinder link arm.
Remove Front Door Lock Cylinder
6. Disengage clip holding lock cylinder into outside handle.
7. Pull lock cylinder from door handle.
INSTALLATION
1. Engage clip into outside handle to hold lock cylinder.
Install Front Door Lock Cylinder
2. With link arm toward rear of vehicle, push lock cylinder into door handle until clip snaps into place.
3. Insert lock linkage into lock cylinder link arm.
4. Engage clip to hold lock linkage to lock cylinder link arm.
5. Engage vehicle theft alarm (VTA) switch onto back of lock cylinder.
6. Verify door lock operation.
7. Install water shield and door trim panel.
