Grand Voyager L4-2.4L DOHC (1996)
1.
Open the liftgate.
2.
Disengage the clips attaching the liftgate upper frame molding and separate the molding from the vehicle.
3.
Disengage the clips attaching the liftgate upper frame side moldings and separate the moldings from the vehicle.
4.
Remove the screws attaching the assist handle to the liftgate.
5.
If equipped, use trim stick (C-4755 to pry the courtesy lamps from the liftgate trim panel then disconnect the wire connector from the lamp and set
the lamp aside.
6.
Disengage the hidden clips holding the trim panel around the perimeter of the liftgate and separate the trim panel from the vehicle.
7.
Remove the bolts attaching the liftgate power lock motor to the liftgate.
8.
Disengage the liftgate power lock motor from the wire connector and linkage. Separate the liftgate power lock motor from the vehicle.
9.
Install the new liftgate power lock motor (P/N 4675782) by reversing the previous steps.
POLICY: Reimbursable within the provisions of the warranty.
