plymouth Workshop Repair Guides

Plymouth Workshop Service and Repair Manuals

Rear Brakes - Moan/Howl Noise|Page 7278 > < Rear Brakes - Cyclic Rubbing Noise|Page 7272
Page 1
background image

Technical Service Bulletin # 05-01-97

Date: 970214

Rear Brakes - Moan/Howl Noise

NO: 05-01-97

GROUP: Brakes

DATE: Feb. 14, 1997

SUBJECT: 
Rear Brake Moan/Howl Noise

THIS BULLETIN SUPERSEDES TECHNICAL SERVICE BULLETIN 05-06-96 REV. A, DATED DEC. 6, 1996, WHICH SHOULD BE REMOVED
FROM YOUR FILES AND NOTED IN THE 1997 TECHNICAL SERVICE BULLETIN MANUAL (PUBLICATION NO. 81-699-97010). ALL
REVISIONS ARE HIGHLIGHTED WITH **ASTERISKS** AND REVISES THE SUBJECT, REPAIR PROCEDURE AND PARTS REQUIRED.

MODELS: 
1996 - 1997 (NS) Town & Country/Caravan/Voyager

NOTE

THIS BULLETIN APPLIES TO VEHICLES BUILT PRIOR TO SEP. 27, 1996 (MDH 0927XX) AT THE ST. LOUIS ASSEMBLY PLANT
(LETTER "B" IN THE 11TH POSITION OF THE VIN) AND PRIOR TO OCT. 28, 1996 (MDH 1028XX) AT THE WINDSOR ASSEMBLY
PLANT (LETTER "R" IN THE 11TH POSITION OF THE VIN).

SYMPTOM/CONDITION:

A howling, moaning noise from the rear brakes during low speed stops, or wire brush-like noise and/or squealing during any stops. These brake noises
can occur at any time, not just the first few stops of the day, like the noise normal overnight corrosion build up can cause.

DIAGNOSIS:

If the vehicle operator describes the subject Symptom/Condition test drive the vehicle to verify. Perform the Repair Procedure if the symptom/condition
is experienced during the test drive.

PARTS REQUIRED:

AR (2)

04238730

Spring, Brake Shoe

1

04883833AA

Kit, Brake Shoe

2

04883830AA

Cylinder, Rear Wheel

**1

04883068

Lubricant, Wheel Cylinder

AR (6)

04238721

Plug, Backing Plate

AR (1)

04318025

Sealer, RTV**

POLICY: Reimbursable within the provisions of the warranty. 

TIME ALLOWANCE:

Labor Operation No:

05-70-07-91

1.2 Hrs.

FAILURE CODE: P8 - New Part

Repair Procedure

This bulletin involves the replacement of the rear brake shoes, rear wheel cylinders and if not already equipped the installation of additional brake shoe
springs.

1.

Raise the vehicle on an appropriate hoist.

2.

Remove the rear wheel/tire assemblies.

3.

Remove the brake drums.

**4. Peel back the edge of both boots on a revised wheel cylinder (p/n 04883830AA) to dislodge the boots from grooves in wheel cylinder casting.

Rear Brakes - Moan/Howl Noise|Page 7278 > < Rear Brakes - Cyclic Rubbing Noise|Page 7272