Grand Voyager L4-2.4L DOHC (1996)
5. Install front brake caliper back over braking disc and align with caliper mounting holes on steering knuckle. Caliper is installed by first installing
bottom of caliper under machined abutment on bottom of steering knuckle and then rotating top of caliper toward steering knuckle. Install the disc
brake caliper to steering knuckle attaching bolts and tighten to a torque of 19 Nm (168 in.lbs.).
6. Install wheel and tire assembly on vehicle. Tighten the wheel mounting stud nuts in proper sequence until all nuts are torqued to half specification.
Then repeat the tightening sequence to the full specified torque of 129 Nm (95 ft.lbs.).
7. Lower vehicle to the ground.
CAUTION: When tightening hub/bearing assembly to stub shaft retaining nut, do not exceed the maximum torque of 244 Nm (180 ft.lbs.).
8. With vehicle brakes applied to keep vehicle from moving, torque stub shaft to hub/hearing assembly retaining nut to 244 Nm (180 ft.lbs.).
9. Check the Toe setting on the vehicle and reset if not within specifications.
