Grand Voyager L4-2.4L DOHC (1996)
Fig. 10 Tripod Removal From Housing
4. With interconnecting shaft on an angle to joint housing, gently pull on shaft until one of tripod bearings is free of plastic retaining collar. Gently
pull on shaft until all rollers are free of housing.
5. On models with spring and cup, remove spring and cup from joint housing.
Fig. 11 Outer Snap Ring Removal
6. On all models, remove outer snap ring from interconnecting shaft.
7. Remove tripod assembly from interconnecting shaft by tapping on body of tripod assembly with a suitable brass hammer. Do not hit outer
bearing when removing assembly from interconnecting shaft.
8. If replacing boot, proceed as follows:
